Panasonic SC-PM272 Operating Instructions Manual page 26

"NO DISC"
• You have not put in a disc.
"NO PRESET"
• DAB memory presetting has not been done.
"NO PLAY"
• There is no album or track in the USB device.
• Examine the content. You can only play supported format.
• The system may have a problem. Switch off the system and then switch on again.
"NO SIGNAL"
• The station cannot be received. Adjust the antenna.
"PLAYERROR"
• You played an unsupported MP3. The system will skip that track and play the next one.
"REMOTE 1"
"REMOTE 2"
• The remote control and the main unit are using different codes. Change the code of the remote control.
– When "REMOTE 1" is shown, press and hold [OK] and [
4 seconds.
– When "REMOTE 2" is shown, press and hold [OK] and [USB/CD] for a minimum of 4 seconds.
"SCAN FAILED"
• Stations cannot be received. Adjust the antenna or do manual tuning.
"USB OVER CURRENT ERROR"
• The USB device is drawing too much power. Disconnect the USB device, switch off the system and then
switch on again.
• Check the connection, it may be caused by a faulty USB cable.
"–VBR–"
• The system cannot show the remaining play time for variable bit rate (VBR) tracks.
Remote control code
When other Panasonic equipment responds to the remote control of this system, change the remote
control code for this system.
Preparation
Press [USB/CD] to select "CD".
To set the code to "REMOTE 2"
█
1
Press and hold [SELECTOR] on the main unit and [USB/CD] on the remote control until
"REMOTE 2" is shown.
2
Press and hold [OK] and [USB/CD] for a minimum of 4 seconds.
To set the code to "REMOTE 1"
█
1
Press and hold [SELECTOR] on the main unit and [
"REMOTE 1" is shown.
2
Press and hold [OK] and [
26
] for a minimum of 4 seconds.
] on the remote control for a minimum of
] on the remote control until