Sharp PG-D120U Operation Manual page 16

Connecting to the Computer RGB Input/Output Terminals
You can connect your projector to a computer for easy projection of full-color computer images, and an external
monitor for simultaneous viewing.
1
IN COMPUTER RGB
RGB Signal
Cable
(Supplied)
2
1
Macintosh Adaptor (Supplied)
U T
Macintosh
B O
R G
O G
A L
A N
RGB Signal
Output Socket
2
Side view of the projector
COMPUTER RGB
IN
RGB Signal
Input Socket
E-16
Side view of the projector
RGB Signal
Input Socket
OUT
IBM-PC (VGA,
ANALOG RGB OUT
SVGA, XGA)
Series (computer)
RGB Signal
Output Socket
OUT
Macintosh
RGB Signal Output Socket
ANALOG
RGB OUT
RGB Signal
Cable
(Supplied)
1. Connecting to an IBM-PC (VGA, SVGA,
XGA) Series computer – 1,024
maximum resolution
Plug the RGB signal cable correctly into the RGB INPUT
terminal on the projector and into the RGB signal output
terminal on the computer, and secure the plugs by
tightening the thumb screws.
Note:
This connection is possible only when using a computer with a
VGA/SVGA/XGA or Mac display output port.
2. Connecting to a Macintosh Series
Computer
640 480 resolution
1 First, connect the supplied Macintosh adaptor to the
RGB signal output terminal on your Macintosh Series
computer, as shown on the left, and secure the plugs
by tightening the thumb screws.
2 Next, firmly plug the supplied RGB signal cable into
both the RGB input terminal on the projector and the
Macintosh adaptor on the computer, and secure the
plugs by tightening the thumb screws.
832 624 resolution
When connecting in the 832
Macintosh adaptor with display mode switching function
available from your local computer dealer.
768
624 dot mode, use a