Sharp AR-BC260 Operation Manual page 182

PROGRAMS FOR COPY MODE
After the [EXECUTE] key is touched and a test patch
printed, a message appears asking you to begin
automatic adjustment. Place the test patch on the
document glass as shown below and touch the
[EXECUTE] key.
Yellow
Black
Magenta
Cyan
NOTE
Lay approximately five sheets of copy paper that
are the same size as the test patch on top of the set
test patch, and gently close the document cover.
When a message appears informing you that auto
color calibration is completed, touch the [OK] key to
end the procedure.
NOTE
Before executing this program, check to see if the
registration adjustment is correct. If not, execute
[AUTO ADJUSTMENT]
adjustment] on page 12.
B/W 600dpi scanning mode for document feeder
The resolution for copying in black and white from the
reversing single pass feeder can be changed from 600
x 300 dpi to 600 x 600 dpi (high quality mode). When
high quality mode is used, fine print and thin lines are
reproduced with greater clarity, however, the scanning
speed is slower. If you prefer a faster scanning speed,
do not enable high quality mode.
When high quality mode is not selected, the following
conditions must be satisfied in order to scan at 600 x
300 dpi and attain the fastest speed.
Conditions for fast job speed (all must be satisfied):
• The copy ratio must be set to 100%
• AUTO, TEXT, TEXT/PRTD.PHOTO, or TEXT/
PHOTO must be selected for the exposure, and
neither "COPY OF COPY" nor "COLOR TONE
ENHANCEMENT" are selected.
• When using a special function, only the following
special functions can be used with 600 x 300 dpi
resolution:
MARGIN SHIFT,
TRANSPARENCY INSERTS, COVERS, MIRROR
IMAGE, EXTRA SIZE
16
in [Registration
ERASE, CENTERING,
ENABLE/DISABLE SETTINGS
"Enable/Disable settings" consists of the following
programs:
G Disabling deletion of job programs
G Disabling of bypass-tray in duplex copy
G Disabling of covers mode
G Disabling of auto paper selection
Disabling deletion of job programs
This program is used to prevent stored programs from
being replaced or deleted. When this program is set,
storing of job programs is also disabled.
Disabling of bypass-tray in duplex copy
(Only when an optional duplex module/2 x 500
sheet paper drawer is installed)
This program is used to disable the use of the bypass
tray when making duplex copies.
The bypass tray is sometimes used to feed heavy
paper. Loading heavy paper in the duplex module/2 x
500 sheet paper drawer may cause a misfeed or
failure. If heavy paper is frequently used, it is
recommended that you enable this program.
Disabling of covers mode
This program is used to prevent selection of the
COVERS mode.
Disabling of auto paper selection
This program is used to prevent automatic paper
selection. When automatic paper selection is disabled,
the copier will not automatically select a paper tray
containing paper that matches the size of the original
placed on the document glass or in the reversing single
pass feeder.