Maintenance; Specifications; Troubleshooting Chart - Sharp DK-CL6N Operation Manual

Troubleshooting chart (continued)
■ Condensation
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet or
on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on until normal playback is possible (about 1 hour).
Wipe off any condensation on the transmitter with a soft cloth before
operating the unit.
■ If problem occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1 Set the unit to the stand-by mode and turn the power on again.
2 If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, remove the backup
batteries.
■ Clearing all the memory (reset)
Remove the backup battery from the main unit without connecting
the AC/DC adaptor.
Caution:
This operation will erase all data stored in memory including clock,
alarm settings and tuner preset.
■ Before transporting the unit
Remove the iPod from the unit. Then, set the unit to the power
standby mode. Carrying the unit with iPod left docked might damage
both the unit and the iPod.

Maintenance

■ Cleaning the unit
Periodically wipe the unit with a clean soft cloth.
Caution:
● Do not use chemicals for cleaning (gasoline, paint thinner, etc.).
It may damage the unit finishing.
● Do not apply oil to the inside of the unit. It may cause
malfunctions.

Specifications

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may
be some deviations from these values in individual units.
■ General
Power source DC IN 12V
(AC 100 - 240 V ~ 50/60 Hz)
Clock Backup: 3V
AA) x 2
Power P W
consumption
Output power Front speakers:
2 watts minimum RMS per channel into
8 ohms from 100 Hz to 20 KHz, 10% total
harmonic distortion.
Speaker 1-way type speaker system
2.5" (6.5 cm) Full Range
Speaker maximum 4 W/Channel
input power
Speaker rated 2 W/Channel
input power
Output terminals Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Video output: 1Vp-p
Input terminals Auxiliary (audio signal):
500 mV/47 k ohms
Dimensions Width: 9-31/64" (241 mm)
Height: 2-61/64" (75 mm)
Depth: 5-29/32" (150 mm)
Weight P lbs. (P kg)
■ Tuner
Frequency range FM: 87.5 - 108.0 MHz
AM: 530 - 1,720 kHz
14
1A: AC/DC adaptor
(UM-3/SUM-3, R6/