Hunter Barrel 51549 Instruction Manual page 9

1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
Note:
Fan style may vary.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
Ceiling Bracket Downrod
Installing the Blades (CONT):
Finish the blade installation by connecting the
previous blade arm connector to the current
blade's trailing edge hole as shown using
the blade nuts and grommets, found in the
hardware bag, and the blade assembly
screws, found in the
blade screws.
Repeat x6
Assembling the Light
2
2 of 3
Light Kit Screw
bag
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
5
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Hanging Fan
bag. Tighten ALL
bag
6
Wiring Canopy
bag
x6
Blade Screw
IMPORTANT
NOTE: Follow the instructions on the blade as well as
the blade arm connector. Installing them incorrectly
could result in your fan not functioning.
3
Insert a third screw, found
in the
into place and then tighten
all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
Install the three switch housing screws
found in the hardware bag.
Blades
1886
x6
Blade Nut
x6
Grommet
1 of 3
Light Kit Screw
bag
hardware bag,
x3
Switch Housing
Screw
bag
ON
8
Pull Chain