uuOperating the Switches Around the Steering WheeluAuto High-Beam
■
How to Turn Off the Auto High-Beam
You can turn the auto high-beam system off. If you want to turn the system off or
on, turn the ignition switch to ON
while the vehicle is stationary.
AUTO Position
*1: Models with the keyless access system have an ENGINE START/STOP button instead of an
ignition switch.
182
*1
, then carry out the following procedures
w
(
To turn the system off:
With the light switch is in AUTO, pull the lever
toward you and hold it for at least 40 seconds.
After the auto high-beam indicator light blinks
twice, release the lever.
To turn the system on:
With the light switch is in AUTO, pull the lever
www.carobook.com
toward you and hold it for at least 30 seconds.
After the auto high-beam indicator light blinks
once, release the lever.
*
1How to Use the Auto High-Beam
If the Some Driver Assist Systems Cannot
Operate: Camera Temperature Too High message
appears:
•
Use the climate control system to cool down the
interior and, if necessary, also use defroster mode
with the airflow directed toward the camera.
•
Start driving the vehicle to lower the windshield
temperature, which cools down the area around
the camera.
If the Some Driver Assist Systems Cannot
Operate: Clean Front Windshield message
appears:
•
Park your vehicle in a safe place, and clean the
windshield. If the message does not disappear after
you have cleaned the windshield and driven for a
while, have your vehicle checked by a dealer.
1How to Turn Off the Auto High-Beam
If you turn the auto high-beam system off, the system
does not operate until you turn the system on.
Park in a safe place before turning the system off or
on.