Table of Contents
Advertisement
Installation
Hydraulic connections
• Connect the water hose to the water supply
tap (fig. 3) only using the hose supplied with
the appliance (do not reuse old hose-sets).
• SOME MODELS may include one or more of
the following features:
• HOT&COLD (fig. 4):
water mains connection settings with hot and
cold water for higher energy savings. Connect the
grey tube to the cold water tap
one to the hot water tap. The machine can be
connected to the cold water tap only: in this
case, some programs may start a few minutes
later.
• AQUASTOP (fig. 5):
a device located on the supply tube that stops
water flow if the tube deteriorates; in this case,
a red mark will appear in the window "A" and
the tube must be replaced. To unscrew the
nut, press the one-way lock device "B".
• AQUAPROTECT
–
GUARD (fig. 6):
Should water leak from the primary internal
tube "A", the transparent containment sheath
"B" will contain water to permit the washing
cycle to complete. At the end of the cycle,
contact the Customer Service Centre to
replace the supply tube.
Setting
• The washing machine should be installed in its
final position such that the water fill hose is not
kinked or trapped. The corrugated drain hose
should be inserted into suitable drain pipe of
between 50 cm and 85 cm height above the
floor using the curved drain hose support. If
an under sink connection is used the drain
hose must be routed above the sink overfill
opening to prevent back siphoning. Care must
be taken to avoid kinking or trapping the drain
hose (fig. 7).
and the red
SUPPLY TUBE WITH
min 4 cm
+2,6mt
max
min 50 cm
max 85 cm
CH
Overflow
vent
29
Advertisement
Table of Contents
