Miller Millermatic Spoolmate 185 Spool Gun Owner's Manual page 24

2-18. Threading Welding Wire
1
Open pressure assembly.
Close and tighten pressure
assembly, and let go of wire.
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle
OM-1322 Page 20
3 5
2
Pull and hold wire; cut off end.
.
Use pressure indicator
Tighten
scale to set a desired
drive roll pressure.
1
2
3
4
WOOD
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
4
6
.
Hold wire tightly to keep it
from unraveling.
6 in
(150 mm)
Push wire thru guides into gun;
Pressure
Indicator
Scale
Remove gun nozzle and contact tip.
Tighten
1
2
3
4
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Outlet Wire Guide
7 Gun Conduit Cable
Lay gun cable out straight.
7
Tools Needed:
continue to hold wire.
Turn On.
Cut off wire. Close
and latch door.
Ref. 802 714 / S-0627-A