Starting The Programme; Soaking Laundry; Adding Laundry; Cancelling The Programme - Bosch WAV28KH0GC User Manual And Installation Instructions

Table of Contents

Advertisement

Note: Observe the information about
detergents and care products
→ Page 29.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press Start / Reload 
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: -0-.
13.7 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start / Re-
.
load 
To resume the programme, after
3.
the desired soaking time, press
Start / Reload 
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Start / Reload 
1.
The appliance pauses.
.
.
.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start / Reload 
5.
13.9 Cancelling the pro-
gramme
Press Start / Reload 
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 25
Remove the laundry.
3.
→ "Unloading the laundry",
Page 32
13.10 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→ "Buttons", Page 24
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
Set the Spin programme or a pro-
1.
gramme for draining the water.
→ "Programmes", Page 25
Press Start / Reload 
2.
operation en
.
.
.
31

Advertisement

Table of Contents
loading

Table of Contents