Table of Contents
Advertisement
10.2 Detergent dispenser with
AutoDose tanks and manual
compartments
When using detergent and
any other treatments, always
follow the instructions that
you find on the packaging of
the detergent products.
Anyway, we recommend not
to exceed the maximum
indicated level in each
compartment (
If both AutoDose tanks are enabled in
the set programme, liquid detergent and
fabric softener are automatically loaded.
If one of the AutoDose tank or both
are disabled (OFF ) in the set
programme, proceed by manually filling
in the proper manual compartment.
(Manual)
•
AutoDose tanks for liquid
detergent
and fabric softener
.
WARNING!
Do not put powder
detergent in the
AutoDose
compartment.
•
Manual compartment for washing
phase: powder or liquid detergent.
).
AutoDose
Manual
When using liquid
detergent, make sure that
the special container for
liquid detergent is
inserted. Refer to the
"Manual filling the
detergent and additives"
paragraph in this chapter.
The liquid detergent
container is supplied
inside the drum.
•
Manual compartment for liquid
Manual
additives (fabric softener, fabric
conditioner, starch).
•
Maximum level for detergent/
additives quantity.
10.3 AutoDose basic setting
The factory pre-set doses for a large
load are 90 ml for detergent tank and
25 ml for fabric softener tank: the
optimal configuration to meet majority
of use condition. The appliance will
use these settings to calculate the
precise dosage for each wash based
on load size.
However, under extreme conditions (very
soft or very hard water) and particular
type of detergent (such as super
compact), we recommend to adjust the
pre-set dosage by following the
indication given on detergent and fabric
softener container: e.g when using super
compact detergent you may need to
reduce the pre-set dosage considerably.
If the washing results are not satisfying
or there is too much foam during
washing, you may need to change the
factory setting. Read in the paragraph
ENGLISH
23
Advertisement
Table of Contents
