Table of Contents
Advertisement
Trigger Cable Tension Adjustment
1. Relieve pressure. See page 17.
2. Be sure the gun is properly mounted in the holder as
instructed on page 14.
3. Pull the actuator lever (94) forward and hold it. Lift up
on the gun trigger (A) until there is slight resistance.
Visually check to see if there is about 1/32 to 1/16 in.
gap between the trigger lever (B) and where the gun
trigger touches the bar.
4. To adjust the tension, loosen the screw (C) in the
block (48). Slide the block forward to increase the
gap and backward to decrease the gap. Tighten the
screw.
5. Recheck the gap and adjust as needed.
CAUTION
Do not allow the cable (1) to rub against the outside
edges of the slot (H) in the block (48), to prevent
premature wear of the cable. Rotate the block slight-
ly to eliminate rubbing. See Fig. 6, DETAIL A.
How To Mount the Gun
See Fig. 6
FORWARD
94
A
B
DETAIL A
Be sure end jacket of cable
seats here. keep jacket and
seat clean
48
Shown Inverted
Fig. 6
1
45
C
48
1/32 – 1/16 in.
(1–2 mm)
1
45
H
0024
Advertisement
Table of Contents
