Polaris ACE 570 Owner's Manual page 96

MAINTENANCE
Engine Oil
Oil and Filter Change
8. Using a cap-style oil filter
wrench, turn the filter
counter-clockwise to remove
it.
9. Using a clean dry cloth, clean
the filter sealing surface on
the crankcase. Make sure the
old filter o-ring is completely
removed.
10. Lubricate the o-ring on the
new filter with a film of fresh
engine oil. Check to make
sure the o-ring is in good
condition.
11. Install the new filter and turn by hand until the filter gasket contacts
the sealing surface, then turn and additional 1/2 turn.
12. Always clean away all dirt and debris from the dipstick area before
removing the dipstick. Remove the dipstick and fill the sump with
two quarts (1.9 l) of recommended oil.
13. Reinstall and tighten the dipstick.
14. Make sure the transmission is in PARK. Apply the brakes.
15. Start the engine. Allow it to idle for one to two minutes.
16. Stop the engine. Inspect for leaks.
17. Re-check the oil level on the dipstick and add oil as necessary to
bring the level to the upper mark on the dipstick.
18. Dispose of used filter and oil properly.
94
Oil Filter