Customer Service And Spare Parts / Technical Specifications; Installation Positioning - Zanussi ZQS 6124 Instruction Booklet

Hide thumbs Also See for ZQS 6124:
Table of Contents

Advertisement

Available languages

Available languages

Customer service and spare parts
If you cannot find the remedy for a malfunction in
these operating instructions, please contact your
dealer or our customer service department and
consult the Guarantee card.
Selective ordering of replacement parts can save
unnecessary travel and costs.
For this reason always provide the following
appliance information:
¥ Model Name
¥ Model Number (PNC)
¥ Serial Number (S-No.)
Technical specifications
The technical data is indicated in the rating plate on the
If there is a power failure when food is in the freezer, do not open the door of the freezer
compartment. The frozen food will not be affected if the power cut is of short duration (up to 12
hours) and the freezer compartment is full, otherwise, it is recommended that the food should be
used within a short time (a temperature increase of the frozen food shortens its safe storage
period).
Installation
Take utmost care when handling your
appliance so as not to cause any damages to
the cooling unit with consequent possible fluid
leakages.
¥ During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
¥ Important: if the supply cable is damaged, it must
be replaced by authorised service or qualified
personnel using a special cable of the same type.
Positioning
¥ Unpack the cabinet and check that it is in good
condition and free of any transport damage.
¥ The appliance must not be located close to
radiators or gas cookers.
¥ Avoid prolonged exposure of the appliance to
direct sunlight.
¥ For building-in and door reversibility refer to the
relevant instructions.
This information can be found on the rating plate
inside the cabenit on the left hand wall. We
recommend that you enter this information here, so
that it is handy if needed.
right side inside the appliance.
The climate classification can be found on the rating
plate, which is located inside the cabinet on the right
hand wall.
The following table shows which ambient
temperature is correct for each climate classification:
Climate
classification
SN
N
ST
T
When the ambient temperature is not included
within the range indicated for the class of this
appliance, the storage temperature in the
appliance cannot be guaranteed; therefore it is
advisable to use the food stored as soon as
possible.
for an ambient temperature of
+10 to +32¡C
+16 to +32¡C
+18 to +38¡C
+18 to +43¡C
53

Advertisement

Table of Contents
loading

Table of Contents