Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZQS3124A
Summary of Contents for Zanussi ZQS3124A
- Page 1 User manual Refrigerator ZQS3124A...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if…... - Page 3 Make sure that the power plug is not squashed or • Do not clean the appliance with metal objects. damaged by the back of the appliance. A squash- • Do not use sharp objects to remove frost from the ap- ed or damaged power plug may overheat and pliance.
-
Page 4: Operation
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials. -
Page 5: Helpful Hints And Tips
Thawing Positioning the door shelves Deep-frozen or frozen food, prior to being used, can be The model is equipped thawed in the refrigerator compartment or at room temper- with a door shelf compart- ature, depending on the time available for this operation. ment Small pieces may even be cooked still frozen, directly For more thorough clean-... -
Page 6: Care And Cleaning
• the freezing process takes 24 hours. No further food to • it is advisable to show the freezing in date on each in- be frozen should be added during this period; dividual pack to enable you to keep tab of the storage time. -
Page 7: What To Do If
Defrosting the freezer Cleaning the air channels A certain amount of frost will always form around Remove the plinth the top compartment. (1), then the ventila- tion grille (2); Important! Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Clean the ventilation 3 2 1 grille. - Page 8 Problem Possible cause Solution The lamp is defective. Refer to "Replacing the lamp". The compressor operates contin- The temperature is not set correctly. Set a higher temperature. ually. The door is not closed correctly. Refer to "Closing the door". The door has been opened too fre- Do not keep the door open longer than quently.
-
Page 9: Technical Data
Remove the screw Install the lamp cover. from the lamp Tighten the screw to the lamp cover. cover. Connect the plug to the mains socket. Remove the lamp Open the door. Make sure that the light comes on. cover (refer to the Closing the door illustration). -
Page 10: Environmental Concerns
Ventilation requirements Important! The wires in the mains lead are coloured in accordance with the following code: The airflow behind the ap- 5 cm pliance must be sufficient. min. 200cm Green and Yellow: Earth C Brown: Live min. D Blue: Neutral 200cm As the colours of the wires in the mains lead of this appli-... - Page 12 www.zanussi.com/shop...