Table of Contents
Advertisement
1
2
E
D
C
5.8 Electrical connection
At the end of installation you can connect
the mains plug to the mains socket.
The rating plate and the 'Technical Data'
chapter indicate the necessary electrical
ratings. Make sure that they are
compatible with the mains power supply.
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
Connect the appliance to an earthed
socket.
Counter-magnet
The appliance is pre set for a magnetic
closure.
For a correct closure:
N
1. Position the screw C and the counter-
magnet D on the magnetic plate N. Lean
the cupboard door against the screw until
it leaves a mark.
2. Open the cupboard door and screw the
counter-magnet D (steel disk + rubber
ring E) with the screw C in the inner side
of the cupboard door, where the screw
left the mark as described in the first
step.
The power supply cable must be easily
accessible after installing the appliance.
For any electrical work required to install
this appliance, contact our Authorised
Service Centre.
The manufacturer does not accept any
responsibility for damage or injury
through failure to comply with the above
safety precaution.
Flexible machine stopper
The supplied plastic stopper
can be only installed when the
appliance installation is
complete, to avoid movement
outward. Fix it on the furniture,
near the front panel taking as
reference height the middle of
the door, on the opposite
side of the hinges.
ENGLISH
17
Advertisement
Table of Contents
