Advertisement
BASIC HAIR CARE INSTRUCTIONS
The Copper Brilliance collection features copper infused coatings for even
heat transfer and beautiful, sleek results.
•
Wash and condition the hair as normal.
•
Squeeze out excess moisture with a towel and comb through.
•
For best results, dry your hair as normal until it is about 70-80% dry.
•
Divide the hair into sections, style the lower layers first.
Note: This appliance is not suitable for use on synthetic wigs or hair
extensions.
COPPER INFUSED CERAMIC BARREL
The advanced ceramic barrel releases copper micro-conditioners onto the
hair for even heat transfer and fast salon performance.
TO FIT/REMOVE ATTACHMENTS
Fit the attachment before you turn on the appliance.
CAUTION: Attachments can become hot during use, let them cool before
removing.
1.
To remove, twist the attachment until the markings line up as shown
in figure A and pull it off the power handle.
2.
To fit an attachment, align the symbols on the power handle and
attachment as shown in figure B then twist the attachment until it
locks into place.
SPEED AND TEMPERATURE SETTINGS
1.
Plug your styler in to the mains power supply.
2.
Turn your air styler on and select the appropriate setting for your hair
by sliding the speed/heat selector switch.
3. Your air styler has three settings:
• High heat/speed (O): Thick and difficult to style hair.
• Low heat/speed (N): Thin/fine, damaged or bleached hair.
• Cool ( ): Helps to set your style with cool air.
CREATE VOLUME USING THE 38MM BRUSH
•
To dry your roots and add volume, place the brush underneath the
section close to the roots and hold for a few seconds, lifting the hair
as you dry.
5
Advertisement
