Philips 9000 Series Manual page 17

- To ensure the best result, we advise you to pre-trim your beard if
you have not shaved for 3 days or longer.
Dry shaving
1 Switch on the appliance.
2 Move the shaving heads over your skin in circular movements (Fig.
20).
Note: Circular movements provide better shaving results than
straight movements.
3 Clean the appliance after use (see 'Cleaning and maintenance').
Wet shaving
You can also use this appliance on a wet face with shaving foam or
shaving gel.
To shave with shaving foam or shaving gel, follow the steps below:
1 Apply some water to your skin (Fig. 21).
2 Apply shaving foam or shaving gel to your skin (Fig. 22).
3 Rinse the shaving unit under the tap to ensure that the shaving
unit glides smoothly over your skin (Fig. 23).
4 Switch on the appliance.
5 Move the shaving heads over your skin in circular movements (Fig.
20).
Note: Rinse the shaving unit regularly to ensure that it continues to
glide smoothly over your skin.
6 Dry your face.
7 Clean the appliance after use (see 'Cleaning and maintenance').
Note: Make sure you rinse all foam or shaving gel off the
appliance.
Using the click-on attachments
Note: The accessories supplied may vary for different products. The
box shows the accessories that have been supplied with your
appliance.
Removing or attaching the click-on attachments
1 Make sure the appliance is switched off.
2 Pull the attachment straight off the appliance (Fig. 24).
13
English