Adjusting The Projector Function ("Prj-Adj1/2" Menu); Auto Sync (Auto Sync Adjustment); Auto Power Off Function; Auto Restart Function - Sharp PG-D2500X Operation Manual

Adjusting the Projector Function ("PRJ-ADJ1/2" Menu)

Q PRJ-ADJ1
Pict. SIG SCR
Auto Sync
Auto Power Off
Auto Restart
Speaker
RS-232C
Fan Mode
System Lock
Keylock
SEL./ADJ.
1 Auto Sync (Auto Sync
Adjustment)
Selectable
items
On Auto Sync adjustment will occur when
the projector is turned on or when the
input signals are switched, when
connected to a computer.
Off Auto Sync adjustment is not
automatically performed.
Note
• Auto Sync adjustment is also performed by
pressing AUTO SYNC.
• The Auto Sync adjustment may take some
time to complete, depending on the image of
the computer connected to the projector.
• When the optimum image cannot be achieved
with Auto Sync adjustment, use manual
adjustments. (See page 44.)

2 Auto Power Off Function

Selectable
items
On When no input signal is detected for
more than 15 minutes, the projector will
automatically enter Standby mode.
Off The Auto Power Off function will be
disabled.
Note
• When the Auto Power Off function is set to
"On", 5 minutes before the projector enters
Standby mode, the message "Enter STANDBY
mode in X min." will appear on the screen to
indicate the remaining minutes.
PRJ-ADJ1 PRJ2
On
On
On
On
9600bps
Normal
Disable
Off
ENTER END
Description
Description
Menu operation n Page
Q PRJ-ADJ2
Pict. SIG SCR
Quick Start Menu
FUNCTION Button
STANDBY Mode
® TM
DLP Link
DLP ® Link TM Invert
All Reset
Lamp Timer(Life)
SEL./ADJ.

3 Auto Restart Function

Selectable
items
On If the power cord is unplugged from the
outlet or the breaker switch is turned off
when the projector is on, then the
projector automatically turns on when
the power cord is plugged into the AC
outlet or the breaker switch is turned on.
Off The projector does not turn on
automatically when the power cord is
plugged into the AC outlet or the
breaker switch is turned on.

4 Speaker Setting

Selectable
items
On The audio signal is output from the
internal speaker.
Off The audio signal is not output from the
internal speaker.
5 Selecting the Transmission
Speed (RS-232C)
Make sure that both the projector and
computer are set for the same baud rate.
Selectable
items
9600bps Transmission speed is slow.
38400bps
115200bps Transmission speed is rapid.
PRJ1 PRJ-ADJ2
On
Input Search
Quick Start
Off
0 h 0 min 100%
ENTER END
Description
Description
Description
39
49