Table of Contents
Advertisement
BasX MR1
Care and Maintenance
Periodic Maintenance
Your BasX MR1L requires no periodic maintenance or calibration.
Cleaning your MR1L
•
If necessary, the MR1L should be cleaned gently with a soft rag.
•
If something sticky gets on the front panel or case of the MR1L, it should be cleaned with
a mild cleaning solution applied to a soft cloth, followed by wiping with a clean cloth
dampened with plain water and drying with a soft dry rag or cloth.
Note: DO NOT spray water or cleaning solution directly onto the front or rear panel
of the MR1L.
Installing Firmware Updates
From time to time Emotiva may issue firmware updates for your MR1L. We strongly recommend
that you only install firmware that was downloaded from the official Emotiva website, or that you
received from Emotiva Technical Support staff.
To install a firmware update on your MR1L:
1) Download the firmware file from our website or the link or e-mail attachment provided by our
Technical Support representative.
2) Place the firmware update file on a USB stick formatted with the Fat32 operating system
(any commercial USB stick formatted to work on both Apple and Windows computers should
work fine). Place the file into the main or root directory of the stick.
Note: If the firmware update is provided in the form of an archive, such as a Zip file, extract the
firmware update file from the archive onto the stick.
3) Plug the USB stick into the rear panel USB connector labelled Update.
Note: There are two different ways to initiate the firmware update. With both, once the update
starts, the front panel will display the status of the update. Depending on which method you
use, after the update completes, the MR1L may turn On or return to Standby.
4a) While the USB stick remains inserted, power the MR1L Off, allow it to remain off for twenty
seconds, then power it back On. The MR1L will recongize that a firmware update is available and
will proceed to perform the update.
4b) With the MR1L On, go into the Setup Menu, and select Setup | About | Software Update.
Select Yes when prompted whether you want to do a software update.
4c) Once the update is complete the MR1L will restart and display the new firmware version.
4d) Remove the USB stick when the update is complete.
WARNING: *DO NOT* unplug the USB stick or turn the MR1L Off during the firmware update.
9.2 Channel Cinema Receiver
L
Page 36
Advertisement
Table of Contents
