Table of Contents
Advertisement
(L) and restart.
Please note: removing the jug before all the coffee
requested has been delivered does not interrupt coffee mak-
ing, but merely blocks flow into the jug. If you want to pour
out a little coffee immediately, you should do so as rapidly as
possible in order to avoid the coffee overflowing.
Cleaning and maintenance
Before maintenance or cleaning of the appliance, turn off,
unplug from the mains socket and allow to cool.
•
Do not use solvents or abrasive detergents to clean the
coffee maker. Just wipe with a soft damp cloth.
•
Never immerse the coffee maker in water. It is an elec-
trical appliance.
•
The water tank filter (H) can be reached through the
coffee compartment and water tank lid (B) (fig. 7).
Clean when necessary.
Descaling
If the water in your area is hard, limescale builds up over
time. These deposits may affect correct operation of the ap-
pliance. You are recommended to descale the coffee maker
every 60 coffee making cycles. To descale, always use special
commercially available descaling products for drip coffee
makers.
1. Dilute the product in the jug, following the instructions
on the descaler pack.
2. Pour the solution into the water fill compartment.
3. Place the jug on the warming plate (M).
4. Press the
button (L), percolate the equivalent of one
cup then turn the appliance off.
5. Leave the solution to work for 15 minutes, then repeat
operations 4 and 5.
6. Turn the appliance on and deliver the water until the
tank is completely empty.
7. Rinse by operating the appliance with water only at
least 3 times (3 complete tanks of water).
Failure to clean as described above invalidates the guarantee.
Technical data
Mains voltage:
Absorbed power:
Weight:
Disposing of the appliance
•
•
•
Troubleshooting
220-240V ˜ 50/60Hz
650W
1.250 kg
9
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste sepa-
ration and recycling centre.
The appliance complies with the following EC
directives:
Low Voltage Directive 2006/95/EC and subsequent
amendments;
EMC Directive 2004/108/EC and subsequent amend-
ments
EC Regulation 1275/2008 for standby
Problem
Probable cause
The coffee takes
The coffee maker
longer to brew.
needs to be de-
scaled.
The coffee has an
Insufficient rin-
acidic taste.
sing after desca-
ling.
use
en
Solution
Descale the ma-
chine as descri-
bed in the sec-
tion DESCALING.
Rinse the machi-
ne as described
in the section
DESCALING.
Advertisement
Table of Contents
