Table of Contents
Advertisement
FIREPLACE
INSTALLATION
Continued
INSTALLING OPTIONAL
WIRELESS HAND-HELD
REMOTE CONTROL
ACCESSORY - GHRC
NOTICE: Use only alkaline bat-
teries (not included).
Installing Remote Receiver
1. Open bottom louver and locate the
switch bracket on the left.
2. Unscrew the switch bracket. Lean
bracket forward so you are able to ac-
cess the back of the remote receiver.
3. Locate the battery clip mounted on the
back of the receiver. Slide a 9-volt al-
kaline battery (not included) through
the clip.
4. Attach the terminal wires to the battery.
5. Remove the wire that runs from TH to
TPTH from the valve (see Figure 40).
6. Connect wires from receiver to TH and
TPTH on the valve (see Figure 41).
7. Replace the switch bracket.
Figure 40 - Disconnecting TH to TPTH
Wire
To Wall Optional
Remote Accessory
t
Figure 41 - Control Valve Terminals
105980
Receiver
Battery Clip
9-Volt Alkaline Battery
Figure 42 - Attaching Alkaline Battery to
Receiver
Installing 9-Volt Alkaline Battery
in Hand-Held Remote Control
Unit
1.
Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to a 9-volt bat-
tery (not included). Place battery into
the battery housing.
3.
Replace battery cover onto remote con-
trol unit.
Battery Cover
Terminal
Wires
9-Volt
Alkaline
Battery
Figure 43 - Installing Alkaline Battery in
Hand-Held Remote Control Unit
REMOVING/REPLACING
GLASS DOOR
You must remove glass door to install op-
tional brick liners, logs, lava rock, and em-
ber material.
CAUTION: Do not operate this
fireplace with a broken glass door
panel or without the glass door
panel securely in place. For re-
placement part information see
Replacement Parts , page 30.
1.
Remove the upper louver panel by lift-
ing upward and out (see Figure 44).
2.
Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
21
OWNER'S MANUAL
3.
Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 45).
4.
To replace glass door, follow the above
instructions in reverse.
Terminal
Wires
Remote
Control Unit
Figure 44 - Removing Top Louver Panel
Screw
Battery
Housing
Lower Bracket for
Glass Door Assembly
Figure 45 - Removing/Replacing Glass Door
Top Louver
Panel
Glass Door
Assembly
Continued
Advertisement
Table of Contents
