Removing And Replacing The Hard Disk Drive - Epson ActionNote 650 User Manual

14. Turn the computer over and open the LCD screen.
15. Run the System Configuration utility, as described in
Chapter 1, to make sure your computer recognizes the new
memory configuration. (As soon as you turn on the
computer, it will prompt you to run the SCU because of the
memory size mismatch.) If you later remove or change the
memory module, be sure to run the SCU again.
16. If you are using Suspend to Disk as your suspend mode, you
should recreate the Suspend to Disk data file on your
computer's hard disk drive so its size corresponds to your
new memory size. See "Using Suspend To Disk Mode" in
Chapter 3 for instructions.

Removing and Replacing the Hard Disk Drive

If you need to remove the hard disk drive, follow these steps:
1. Turn off the computer and any peripheral devices.
2. Disconnect any external device cables connected to the
computer.
3. Close the LCD screen, if necessary.
4. Turn the computer over so the bottom faces up.
5. Follow the steps on pages 4-10 through 4-11 to remove the
memory module cover and the CPU heat spreader.
Installing Optional Devices 4-13