Haier HWD1600 Service Manual page 21

SERVICE MANUAL
HWD1600
Error message: The required water level is not reached within 8 min.
Trouble shooting:
Check if water is leaking from washer
bottom. Inlet pipe. drain pipe or
other pipe connection
N
Check if tap is closed or water
pressure is too
between0.05 -1 MPa)
N
Check if inlet valve is jammed
N
Draw out the dispenser and check if
water is entering
N
Turn on power, and set pre-wash
mode, then start. Check the import
voltage of electromagnetic valve by
multimeter is it between AC 110-120V?
N
Check if export voltage from PCB to
electromagnetic valve, is it between
AC 110-120V?
N
Replace PCB
All manuals and user guides at all-guides.com
low (usual
Y
Front Load Clothes Washer & Dryer Combo
Connect it well.
Y
Open the tap or wait for normal water
Y pressure to use
Clean inlet valve
Y
Observe if the height of drain pipe not
reach 80 cm. If water level pressure
switch and the hose is leaking gas
Y
Electromagnetic valve must be broken, please
replace it.
Y
The wire connected PCB and inlet valve is not
properly. Please reconnect it or replace it.