Engine Oil Filter; Air Filter; Clean Air Screen; To Service Pre-Cleaner/Cartridge - Craftsman 917.2720601 Owner's Manual

16.0 hp, 42" mower electric start automatictransmission
Table of Contents

Advertisement

8. Use gaugeon oil
fill cap/dipstick for
checking level.
Insert dipstick into the
tube and rest the oil fill cap on the
tube.
Do not thread the cap onto the
tube when taking reading.
Keep oil
at "FULU'
line on dipstick.
Tighten cap
onto the tube securely when finished.
ENGINE OIL FILTER
Replace the engine oil filter every season
or every other oil change if the tractor is
used more than 100 hours in one year.
1.
Drain oil from engine crankcase
(See
"TO CHANGE
ENGINE
OIL" in this
section
of manual,
through
step
remove
drain plug).
2.
Remove
oil filter and wipe off filter
adapter.
3. Apply
a thin coating
of new engine oil
to the rubber gasket on replacement
oil filter.
4.
Install replacement
oil filter on filter
adapter. Turn oil filter clockwise until
rubber gasket contacts the filter
adapter, then tighten filter an addi-
tional 1/2 turn.
5.
Fill crankcase with new oil (See "TO
CHANGE
ENGINE
OIL" in this section
of manual).
For approximate
capacity
see "PRODUCT
SPECIFICATIONS"
section of this manual.
6. Start the engine and check for oil
leaks. Correct any leaks before
placing engine into full operation.
)i(Filter
AIR FILTER
Your engine will not run properly using a
dirty air filter.
Clean the foam pre-cleaner
after every 25 hours of operation or every
season.
Service paper cartridge every
100 hours of operation or every season,
whichever occurs first.
Service air cleaner more often under
dusty conditions.
1. Remove
knob and cover.
2.
Remove wing nut and air cleaner from
base.
TO SERVICE
PRE-CLEANER
3.
Slide foam pre-cleaner
off cartridge.
4. Wash it in liquid detergent
and water.
5. Squeeze
it dry in a clean cloth.
Allow
it to dry.
6. Saturate
it in engine oil. Wrap it in
clean, absorbent
cloth and squeeze
to
remove
excess
oil.
TO SERVICE
CARTRIDGE
1. Replace
a dirty, bent, or damaged
cartridge.
NOTE:
Do not wash the paper cartridge
or use pressurized
air, as this will
damage
the cartridge.
2.
Reinstall
the pre-cleaner
(cleaned
and oiled) over the paper cartridge.
3.
Reassemble
air cleaner,
wing nut,
cover and tighten
knob securely.
Air Cleaner
Cover
Cover
(nob
Nut
Foam
Pre-
Rubber
Cleaner
Paper
Ca_ridge
Screen
Base
Cap/
Dipstick
CLEAN
AIR SCREEN
Air screen must be kept free of dirt and
chaff to prevent engine damage from
overheating.
Clean with a wire brush or
compressed
air to remove dirt and
stubbom dried gum fibers.
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents