Table of Contents
Advertisement
Dear Customer,
Thank you for choosing a McCulloch product. You are
thereby part of a story that started long ago, when the
McCulloch Corporation started its manufacturing of
engines during World War II. In 1949, when McCulloch
introduced its first light one-man chainsaw, woodworking
would never be the same again.
The line of innovative chainsaws would continue over the
decades, and business was expanded, first by airplane
and kart engines in the 1950s, then by mini chainsaws in
the 1960s. Later, in the 1970s and 80s, trimmers and
blower vacs were added to the range.
Today, as a part of the Husqvarna group, McCulloch
continues the tradition of powerful engines, technical
innovations, and strong designs that have been our
hallmarks for more than half a century. Lowering fuel
consumption, emissions and noise levels are of top
priority to us, as is improving safety and user-friendliness.
We certainly hope that you will be satisfied with your
McCulloch product, as it is designed to be your
companion for a long time. By following this operators
manual's advice on usage, service, and maintenance, its
lifespan can be extended. If you should need professional
help with repair or service, please use the Service Locator
at www.mcculloch.com.
McCulloch has a policy of continuous product
development and therefore reserves the right to modify
the design and appearance of products without prior
notice.
This manual can also be downloaded at
www.mcculloch.com.
Symbols on the machine:
WARNING! Chain saws can be
dangerous! Careless or incorrect use
can result in serious or fatal injury to
the operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
•
Approved protective helmet
•
Approved hearing protection
•
Protective goggles or a visor
This product is in accordance with
applicable EC directives.
6 – English
INTRODUCTION
Noise emission to the environment
according to the European
Community's Directive. The machine's
emission is specified in chapter
Technical data and on label.
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it
with one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING!
Kickback may occur when the nose or
tip of the guide bar touches an object,
and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause
serious personal injury.
The engine is stopped by switching the
ignition off using the stop switch.
Chain brake, activated (right)
Chain brake, not activated
(left)
Air purge.
Refuelling.
Chain oil fill.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
1153988-26 Rev.4 2014-04-15
Advertisement
Table of Contents
