Microwave - Siemens CM724G1 2S Series User Manual And Installation Instructions

Table of Contents

Advertisement

When the food is ready, use
pliance off.
Setting the end time
To achieve good cooking results, only change the set
time before the operation starts and before the cooking
time starts counting down.
Press "End time".
1.
Use
or
to change the time.
2.
Press "Apply".
3.
Cancelling the end time
You can delete the set time at any time.
Press "Stop"
1.
Press "End time"
2.
Use
to reset the time.
3.
Note: For operating modes that always require a
cooking time, the appliance resets the time at which
the cooking time ends to the next possible time.
Press "Start"
4.
9.3 Setting the timer
The timer runs independently during the operation. You
can set the timer when the appliance is switched on or
off, up to 24 hours. The timer has its own signal tone
so that you can tell whether it is the timer or a cooking
time that has elapsed.
Press the
button.
1.
10  Microwave
You can use the microwave to cook, heat up, bake or
defrost food very quickly.
10.1 Cookware and accessories with

microwave

To heat food evenly and avoid damaging your appli-
ance, it is important to only use the right cookware and
accessories.
Follow the cookware manufacturer's instructions.
Unless otherwise specified, place the cookware and
accessory on level 1.
Microwave-safe cookware
Cookware made from heat-resistant, microwave-safe
material:
¡ Glass
¡ Glass ceramic
¡ Porcelain
¡ Temperature-resistant plastic
¡ Fully glazed ceramic without cracks
¡ Serving dishes
Only use cookware with decorative gold or silver
trim if the manufacturer guarantees its suitability for
microwave use.
¡ Supplied wire rack
In microwave-only operation, sheets and trays, e.g.
the universal pan or the baking tray, may create
sparks and are not suitable.
These materials allow microwaves to pass through and
are not damaged.
to switch the ap-
To set the timer, press the relevant time value on
2.
the display, e.g. hour display "h" or minute display
"min".
a The selected value is marked in blue.
Set the timer using
3.
ment bar.
If required, use
to reset the adjustment value.
To start the timer, press "Start".
4.
a The timer counts down.
a The timer remains visible on the display if the appli-
ance is switched off.
a When the appliance is switched on, the display
shows the settings for the current operation. The
timer is displayed in the status bar.
a Once the timer has elapsed, a signal tone sounds.
A note appears on the display confirming that the
timer has finished.
Changing the timer
You can change the timer at any time.
Press the
button.
1.
Press "Pause".
2.
Change the timer.
3.
Press "Start".
4.
Cancelling the timer
You can cancel the timer at any time.
Press the
button.
1.
Reset the timer using
2.
3.
Press "Start".
Cookware that is not microwave-safe
Note: Observe the specifications for preventing mater-
ial damage.
→ "Microwave", Page 6
¡ Metal cookware and bakeware
Microwaves cannot pass through metal. The food is
barely heated or not heated at all. Metal may create
sparks in microwave-only operation.
Cookware when adding microwave to an operating
mode
If you switch on the microwave for another operating
mode, metal is also an option, in addition to
microwave-safe cookware and accessories:
¡ Metal cookware and bakeware
Metal must be kept at least 2 cm from the cooking
compartment walls and the inside of the door.
Always place metal cookware or bakeware in the
centre of the supplied wire rack.
¡ Accessories supplied:
Wire rack
Universal pan
Baking tray
Testing cookware for microwave suitability
If you are unsure whether your cookware is suitable for
use in the microwave, carry out a cookware test.
Microwave en
or
or directly via the adjust-
⁠ .
15

Advertisement

Table of Contents
loading

Table of Contents