Daikin BRC7M530W Operation & Installation Manual page 24

2. Setting the address of wireless remote
controller (It is factory set to "1")
Address
Multiple
setting
5
<Setting from the remote controller>
1. Open the cover on the display of the
wireless remote controller.
2. Press the
same time for 4 seconds or more to go
into the FIELD SETTING mode.
(The liquid crystal display on the remote
controller is shown in Fig. 3.)
3. Press the
multiple setting.
(A/b setting) (Refer to Table 3)
(Each time the button is pressed, the
display changes from "A" to "b".)
4. Press the
1 2 3
The address can be set from 1 to 6, but
set it from 1 to 3 to correspond with the
receiving part. (Transmission printed
circuit board assembly (2)) (It does not
work when it is set from 4 to 6.)
21
2
Fig. 3
and buttons at the
button and select the
buttons for set the address.
4 5 6
5. When the
setting is confirmed and the usual display
returns.
Multiple setting A/b
The command such as operation mode or temperature
setting by this remote controller will be rejected when
the target indoor unit operation is restricted as by an
external control such as centralized control.
Since the setting acceptance is hard to discriminate
with such circumstances there are two setting
options provided to enable discriminating by a
beeping sound according to the operation:
"A: Standard" or "b: Multi System".
4
(Refer to Table 3)
Set the setting according to the customer's intention.
Table 3
Remote Controller
Multiple
setting
3
A:
Standard
(factory
set)
button is pressed, the
Indoor Unit
Display Behavior to the remote
on controller operation
remote when the functions are
controller restricted as by an
external control.
All items Accepts the functions
displayed. except restricted.
(Sounds one long beep
or three short beeps)
There may be a
difference from the
indoor unit status with
remote controller display.
In the operation mode
changeover, temperature
setting or the like are
carried out from the
wireless remote controller,
the indoor unit rejects the
instruction.
(Signal receiving sound
"peeh" or "pick-pick-pick")
As a result, a display
discrepancy between the
operation state of the indoor
unit and the indication on
the wireless remote
controller display occurs.
Other than
the left
Accepts all
items
transmitted
(Sounds
two short
beeps)
The remote
controller
display
agrees with
the indoor
unit status.