DISASSEMBLY OF THE 2DR MODELS
These instructions refer to the 50PY2DR and 60PY2DR
TOOLS REQUIRED
1) Electric or cordless screwdriver with a #2 Phillips head screwdriver bit.
2) Digital Multi-meter
3) Non magnetic potentiometer adjustment tool / blade
4) Diagonal cutters
5) Nylon cable ties
Note: Remember to observe ESD Safety precautions when handling electronic printed circuit boards
and replacing the plasma display panel. Replace all cut cable ties with new ones to secure loose
wires.
Note: The stand must be removed from the plasma tv / monitor before servicing.
REAR COVER
1) If you can not remember the connection locations, label each connector with a marker or use
another method to identify the correct reconnect location.
2) Remove the rear cover screws. The arrows imprinted in metal rear cover indicate the screws that
need to be removed to remove the rear cover.
3) Place the rear cover to the side. Place it in an area where it is protected from damage while
unattached to the unit.
Plasma Training
65
DISASSEMBLY
Disassembly