Channels - Philips 24PHG4032/77 User Manual

More sound settings
You can change the settings in the Sound
menu.
1. Press .
2. Select [Setup] > [TV settings] > [Sound],
then press OK.
3. Select a setting to change, then press OK.
• [Sound style]: Access predefined sound
settings.
[Restore style]: Restore the
•
last-selected predefined sound setting.
• [Bass]: Adjust the bass level of the
speaker and headphones.
[Treble]: Adjust the treble level of the
•
speaker and headphones.
• [Surround mode]: Select a surround
sound mode to enhance your audio
experience.
• [Headphone volume]: Adjust
headphone volume.
[Advanced]: Access advanced settings
•
to enhance your audio experience.
- [Auto volume leveling]: Enable the
reduction of sudden volume changes,
for example, when switching channels.
- [TV speakers]: Select the preferred
speakers to stream audio from the TV.
See Connect your TV > Set up
EasyLink devices > Select speaker
output (Page 34).
- [Clear sound]: Enhance sound quality.
- [Audio Out format]: Select the type
of audio output through the digital
audio output connector. Choose
between [Multichannel] and [Stereo].
- [HDMI side - ARC]: Enable audio
output from the ARC-compliant device
connected to the HDMI side
connector.
- [Audio out delay]: Automatically sync
the image on the TV to the audio from
a connected home theater. You do not
need to use this setting when
connecting the TV to a Philips home
theater.
- [Audio out offset]: Adjust the setting
for audio output delay. Available if
[Audio out delay] is switched on.
Audio format
If an analog TV channel broadcaster streams
stereo audio in multiple formats, you can
select an audio format.
1. Press .
2. Select [Setup] > [Channel settings] >
[Mono/Stereo].
3. Select a setting, then press OK.
Reset picture and sound
You can restore the default picture and
sound settings, while the channel installation
settings remain the same.
1. While you watch TV, press
2. Select [Setup] > [TV settings] > [General
settings] > [Factory settings], then press
OK.
3. Select [OK], then press OK.
All TV settings (except for channel settings)
are reset to the default factory settings.

Channels

Automatic installation
When the TV was switched on for the first
time, a full installation of channels was
performed.
To change your language, country, and
reinstall all available TV channels, you can run
this full installation again.
Start installation
Note: If you are prompted to enter a code,
enter '8888'.
1. Press .
2. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
3. Select your country, then press OK.
4. Select your network, then press OK:
• [Antenna]: Access free-to-air antenna
transmissions.
[Cable]: Access cable transmissions.
•
5. Follow the onscreen instructions to select
other options, if any.
The start menu for channel search is
displayed.
.
EN 19