Related Manuals for Nakamichi NBF618S
Summary of Contents for Nakamichi NBF618S
- Page 1 NBF618S User Manual 6x8" ACTIVE ALUMINUM SUBWOOFER nakamichicaraudio.com nakamichi.global nakamichi.caraudio...
- Page 2 • Installation of the apparatus must be done with great care to prevent damage to your vehicle’s fuel lines, power, and other electrical wiring, hydraulic brake lines, and other systems. If possible, always visit your nearest Nakamichi dealer to perform the installation.
-
Page 3: Accessory List
YOUR SPEAKER • Protect all system wires from sharp edges by carefully routing them, always use rubber grommets to protect wiring and cables whenever you are installing them through metal openings. • Secure all wiring using cable ties or wire clamps to protect them from moving parts and sharp edges. -
Page 4: Panel Controls And Features
PANEL CONTROLS AND FEATURES A. POWER STATUS LED F. INPUT GAIN CONTROL This LED glows green when power is on and no After you have installed your system, turn this problems are present. control to minimum. Turn the head unit on (and the subwoofer will turn on via the remote connection). -
Page 5: Low Level Input Wiring
WIRING LOW LEVEL INPUT WIRING Low-level (RCA) input wiring is preferred for best audio performance. Most trunk and under-seat installations will require a 6-12 feet RCA cable. Always use a high quality cable. NOTE: Do not connect both the high level and low level inputs from your receiver to your amplifier at the same time! Fig.1 Fig.2... -
Page 6: High Level Input Wiring
WIRING HIGH LEVEL INPUT WIRING The high level input(s) should only be used when your receiver lacks RCA outputs. If the RCA outputs are not present, connect the speaker outputs from the receiver to the high level input connector of the amplifier. Be sure to observe polarity to avoid audio phase problems. NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the same time! Fig.3... -
Page 7: Troubleshooting
TROUBLESHOOTING If you experience operation or performance problems with this product, compare your installation with the electrical wiring diagram on the previous pages. If problems persist,read the following troubleshooting tips which may help eliminate the problems. SYMPTOM POSSIBLE REMEDY Check to make sure you have a good ground connection. Check that the Remote Input (Turn-on) has at least 5V DC. - Page 8 CONNECT WITH US ONLINE TO EXPLORE NAKAMICHI’S COMPLETE RANGE, INSTRUCTIONS & SOFTWARE DOWNLOADS AND WARRANTY REGISTRATION. WWW.NAKAMICHICARAUDIO.COM nakamichi.global nakamichi.caraudio Made in China | 中國製造 Nakamichi Corp, Japan...