Table of Contents
Advertisement
CSE-M14T Mobile Rack User's Guide
Installation Instructions
3.1 Packing List
Examine the following items that are included in your shipping package. If any items
are missing or damaged, please contact your retailer immediately.
*One 4-drive Mobile Rack Cage (CSE-M14 ((B)) P)
*Four hot-swap 2.5" HDD trays
*One cooling fan assembly (40MM)
*One screw set for 4 HDDs
*One SAS/SATA Backplane (CSE-SAS-M14EV)
*One SATA Big4 to individual port fan out cable (CBL-0103)
3.2 Tools Needed
The following tools are needed for the installation of the mobile rack into chassis.
1. Phillips Screw Driver
2. Antistatic Strap (recommended)
3.3 Important Safety Guidelines
This product shall only be accessed, assembled and serviced by techni-
cally qualified personnel or technicians. To avoid personal injury and
Stop
property damage, please carefully follow all the Safety Guidelines listed
below before accessing or servicing the CSE-M14T.
Safety Steps
Before accessing the Mobile Rack:
1. Turn off all peripheral devices and the power supply connected to the chassis
and unplug all power cords from the system or the wall outlets.
2. Disconnect all the cables and label the cables for easy identification.
3. Use a grounded wrist strap designed to prevent static discharge when handling
components.
5. Save all the screws and fasteners for later use. (If necessary, label these screws
or fasteners for easy identification.)
6. Follow the instructions given in the following section to remove and install the
cooling fan, hard disks and the rear window.
Chapter 3
8
Advertisement
Table of Contents
