Table of Contents
Advertisement
5-8
Connecting Cables
ATX Power Connector
The primary ATX power supply con-
nector (JPW1) meets the SSI (Super-
set ATX) 20-pin specifi cation. Refer to
the table on the right for the pin defi ni-
tions of the ATX 24-pin power connec-
tor. This connection supplies power to
the chipset, fans and memory.
Note: You must also connect the
8-pin (JPW2) and 4-pin (J32) power
connectors to your power supply (see
below).
Processor Power Connector
In addition to the primary ATX power
connector (above), the 12v, 8-pin
processor power connector at JPW2
must also be connected to your power
supply.
This connection supplies
power to the CPUs. See the table on
the right for pin defi nitions.
Auxiliary Power Connector
The 4-pin auxiliary power connector at
J32 must also be connected to your
power supply. This connection sup-
plies extra power that may be needed
for high loads. See the table on the
right for pin defi nitions.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20
of JF1. Refer to the table on the right
for pin defi nitions.
Chapter 5: Advanced Serverboard Setup
ATX Power 20-pin Connector
Pin Defi nitions (JPW1)
Pin#
Defi nition
Pin #
11
GND8
12
+5V1
13
+5V2
14
3.3V1
15
3.3V2
16
+5V/SB
17
+12V4
18
+12V5
19
+12V6
20
Blcoked
Processor Power
Connector
Pin Defi nitions (JPW2)
Pins
1 through 4
5 through 8
Required Connection
Auxiliary Power
Connector
Pin Defi nitions (J32)
Pins
1 & 2
3 & 4
Required Connection
NMI Button
Pin Defi nitions (JF1)
Pin#
Defi nition
19
Control
20
Ground
5-13
Defi nition
1
GND1
2
GND2
3
GND3
4
GND4
5
GND5
6
GND6
7
GND7
8
+12V1
9
+12V2
10
+12V3
Defi nition
Ground
+12V
Defi nition
Ground
+12V
Advertisement
Table of Contents
