SERVICE AND ADJ
TO REPLACE
HEADLIGHT
BULB
•
Raise hood,
•
Puff bulb holder out of the hole in the backside of the
gritL
°
Replace bulb in holder' and push bulb holder securely
back into the hole in the backside of the griH_
°
Close hood.
°
Raise hood°
•
Unsnap headlight wire connector.
°
Stand in front of tractor° Grasp hood at sides, tiff toward
engine and lift off of tractor.
°
To replace, reverse above procedures.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring°
See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash,
TO ADJUST ATTACHMENT
LIFT SPRING
(See Fig, 32)
•
While holding spring bushing with wrench, loosen jam
nut..
•
Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier attachments°
.
Turn adjustment bolt counterclockwise for' lighter' at-
tachments.
°
Retighten jam nut against spring bushing.
IMPORTANT, DO NOT ADJUST FOR MAXIMUM SPR{NG
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER, ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION_
TO REMOVE
HOOD AND GRILL ASSEMBLY
See Fig, 33)
ADJUSTMENT
SPRING BUSHING
o
ATTACHMENT
JAM NUT
LIFT SPRING
o
_
/_
i;%,,
• : s
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 33
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
(See Fig, 34)
The throttle control has been preset at the factory and
adjustment should not be necessar¥_ Check adiustment as
described below before loosening cable° If adjustment is
necessary', proceed as follows:
°
With engine not running, move throttle control lever to
fast position.
°
Check that speed contro! lever is against stop screw. If
it is not, loosen casing clamp screw and pull throttle
cable until lever is against screw_ Tighten clamp screw
securely_
FIG. 32
26