Table of Contents
Advertisement
en Basic operation
Note: The programme settings are
not saved permanently for the pro-
gramme.
12.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→ "Setting a programme", Page 35
¡ The programme settings have
been adjusted.
→ "Adjusting the programme set-
tings", Page 35
Press and hold Αγαπημένο for
▶
approx. 3 seconds.
Press Αγαπημένο to call up the
saved programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
12.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 31
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 35
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
12.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 35
Press
.
▶
36
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End" .
Note: If "Hot" appears, the appli-
ance cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.7 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Press
.
1.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
you want to avoid or cancel the
cooling process, open the door.
→ "Display", Page 24
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
12.8 Cancelling the pro-
gramme
Press
.
1.
Open the door.
2.
Remove the laundry.
3.
→ "Unloading the laundry",
Page 36
12.9 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
12.10 Put the appliance into
standby mode
Press
.
▶
Advertisement
Table of Contents
