Preparation Before Operation - Daikin FTKB25WAVMV Operation Manual

READ BEFORE OPERATION

Preparation Before Operation

„ To set the batteries
Slide the back cover to
take it off.
„ To operate the remote controller
• To use the remote controller, aim the transmitter at the indoor
unit. If there is anything blocking signals between the unit and
the remote controller, such as a curtain, the unit will not
operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is about 7m.
„ To fi x the remote controller
holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall, a pillar, etc. with the screws
supplied with the holder.
3. Place the remote controller in the remote controller holder.
„ Turn the breaker on
• After the power is turned on, the fl ap of the indoor unit opens and
closes once to set the reference position.
ATTENTION
„ About batteries
• When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approximately one year. If the remote controller display begins to fade
and the degradation of reception performance occurs within a year, however, replace both two
batteries with new size AAA.LR03 (alkaline) batteries.
• The attached batteries are provided for the initial use of the system. The usable period of the
batteries may be short depending on the manufactured date of the air conditioner.
• When battery power has run out, the LCD will begin blinking as an alert that the batteries need
replacing. When the LCD is blinking, the remote controller will stop all operations except to turn
off the air conditioner.
„ About remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fl uorescent lamp (such as
inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to
somewhere else, or consult the shop.
8
1
Position
correctly!
and
2
Set two dry batteries
AAA.LR03 (alkaline).
3
Set the back cover as
before.
Receiver
Remote controller
Remote
controller
Screws
holder