Samsung AC TN4PKC Series Instruction Manual page 30

Installation Procedure
2 Set an address for each indoor unit using the remote control, according to your air conditioning system plan, by
referring to the following table and by following the steps in Common steps for setting the addresses and options
on page 18.
• The indoor unit addresses (main and RMC addresses) are set to 0A0000-100000-200000-300000 by default.
• If indoor units and outdoor units match 1:1, you don't need to set the main address because it is automatically set
by the outdoor unit.
• If you are using on or off controller, set RMC address.
Option SEG1
Function Page
Indication Details
Indication
and
0
details
Option SEG7
Function Page
Indication Details
Indication
and
1
details
CAUTION
• The main address must be set to a value in the range 0 to 14. If you set other values, communication error will occur.
• If any of SEG5 and SEG6 is set to a value in the range A to F, the main address of the indoor unit does not change.
• If SEG3 is set to 0, the indoor unit maintains the existing main address even if SEG6 is set to a new value.
• If SEG9 is set 0, the indoor unit maintains the existing RMC address even if SEG11 and SET12 are set to new values.
30
English
SEG2 SEG3
Setting main
Mode
address
Indication Details Indication
No main
0
A
1
SEG8 SEG9
Setting RMC
address
Indication
Reserved 0
1
SEG4
Details
Reserved
address
Main
address
setting
mode
SEG10
Details
No RMC
Reserved
address
RMC
address
setting
mode
SEG5 SEG6
Indoor unit Indoor unit
number number
Indication Details Indication
Tens
0 to 1 0 to 9
digit
SEG11 SEG12
Group channel
Group address
(x16)
Indication Details Indication
RMC1 0 to 2 RMC2
Details
Units
digit
Details
0 to F