Samsung NQ70 700D Series Installation Manual page 13

Barrier Barrier
A
C
B
A. Trim Left
B. Trim Bottom
C. Screw
DG68-01560A-00_IM_NQ70xx700D,600DxxAA_EN+MES+CFR.indb 13 DG68-01560A-00_IM_NQ70xx700D,600DxxAA_EN+MES+CFR.indb 13
3. Push oven completely into the cabinet
and center the oven into the cabinet
cutout.
4. Remove the tape from front trims.
• Securely fasten the oven to the
cabinet using the screws provided.
• Insert the screws through hole in
trim aligning with hole in lower
oven frame. Do not overtighten
screws.
WARNING
When inserting the oven, use caution not to
deform or damage the barrier underneath.
5. The bottom metal trim are shipped in
the foam packing.
To install the metal bottom trim, see
following instructions.
• Align tab of the bottom trim with a
hole in the left side trim of the unit
as shown. Repeat on the right side.
• Using one screw on each side
of the trim tab, fasten the trim
securely to the oven.
CAUTION
Lower oven door should be removed, before
fastening the trim.
6.
A
C
The upper oven can be fixed with 4 screws,
and the lower oven with 2 screws.
B
A. Trim Left
B. Trim Bottom Large
C. Screw
IMPORTANT NOTE
Keep oven vent ducts unobstructed. The oven vent is located at the bottom of the
oven. This area could become hot during oven use. Never block this vent or place
plastic or heat-sensitive items in front of it.
If the cutout size is larger than
1.5 inches use of the wider bottom trim
is recommended.
NOTE
English 13
2023-04-04 오전 11:45:34 2023-04-04 오전 11:45:34