Studiologic SL-1100 User Manual page 8

CSL
Control Slider
The left slider on the SL-1100 front panel can be programmed to issue any MIDI control change
message. To set the controller number, press and hold a ZONE switch. Press the FUNCTION 4
switch twice, then release both switches. Use the DATA slider to set the controller number (if no
controller is desired, adjust the slider to display a dash"-"). To eat edit mode, press the blinking switch.'
WHEELS
The two control wheels on the Studio-1100 are dedicated to PITCH and MOD functions. The
wheels may be switched on and off for each zone (both will be enabled or both will be disabled
per zone). First press and hold the specific ZONE switch. Press the FUNCTION 2 switch three
times, then release both switches. The LED display will indicate On or OFF. Use the DATA
slider to change the setting. To exit the edit mode, press the blinking switch.'
AFTERTOUCH
The SL-1100 will transmit aftertouch, which allows expressive musical control during the course
of a note. The aftertouch value is determined by the total key pressure on all depressed keys
("channel pressure").
To enable or disable the aftertouch, press and hold a desired zone switch. Press the
FUNCTION 3 switch three times. Adjust the data slider to change the display to ON or OFF.
Press the blinking switch to exit edit mode.
Note: Not all sound modules respond to MIDI aftertouch (channel pressure) messages.
PEDAL
The SL-1100 is equipped with a voltage input for external analog controllers such as a voltage pedal
(available from your Master Controller Keyboard dealer). The pedal input is set to adjust the master
volume (same as front panel slider) but may be reprogrammed to issue any MIDI control change
message.
To set the controller number, press and hold a ZONE switch. Press FUNCTION 4 switch 3 times.
Release both switches. Use the DATA slider to set the controller number (if no controller is
desired, adjust the slider to display a dash "-"). To exit edit mode, press the blinking ZONE
switch. The default setting for this input is controller #7. This value is not issued directly as the
input changes, but is scaled by the initial volume setting for the zone. All other controller-
numbers will cover the range from 0 to 127 as the pedal is moved.
The Sustain input on the SL-1100 back panel may be used with an external footswitch. A MIDI
control change message (#64) will be issued on each zone when the footswitch is actuated. To
enable or disable the sustain messages, press and hold a desired zone switch. Press and hold
the sustain pedal, and then press the Function 4 switch 3 times. Adjust the data slider to change
the display to ON or OFF. Press the blinking zone switch to exit edit mode.
.