Advertisement
Burner, Firebox and Control Knobs
9
'
Place burner assembly into firebox (A). Fasten the burner assembly to the firebox using 5mm fiber washers and
#10-24x1/2" Screw
'
Place firebox onto upper firebox supports. Make sure burner tubes are correctly engaged (B). If burner is not
leveled from left to right, adjust the two screws attaching valve to control panel. Attach short ignitor wire to
ignitor
, Hook venturi clips to main burner tubes and around valve.
'
Attach firebox with #10-24x1/2" screws, fiber washers and #10-24 nuts (C).
'
Push control knobs onto valve stems (C).
A
B
Venturi
Clip
Heat Shield
'
5 10
Attach heat shield with #10-24x1/2" screws and #10-24 nuts. NOTE: Regulator and hose come out by the heat shield.
18 •
463720108
Burner Assembly
Firebox
Fiber Washer
#10-24x1/2" Screw
Short
Ignitor
Wire
Warning: Make sure heat shield is placed
Heat Shield
above the two venturis, or else it drops down
and may fail to protect tank from being
overheated.
(B).
Qty: 6
#10-24x1/2" Screw
Qty: 2
Venturi Clip, Main burner
C
Heat Shield
Qty: 6
Fiber Washer
Qty: 4
#10-24
Flange Nut
Control
Knob
Qty: 2
Qty: 2
#10-24
#10-24x1/2"
Flange Nut
Screw
Advertisement
