Table of Contents
Advertisement
The appliance starts the countdown of the
delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button Départ/Pause to
start the appliance, you can cancel or
change the set of the delay start.
12.9 Cancelling the delay start
To cancel the delay start:
1. Press button Départ/Pause
appliance to pause.
The related indicator flashes.
2. Press button Départ Différé
until the display shows .
3. Press button Départ/Pause
start the programme immediately.
12.10 Interrupting a programme and
changing a option
You can change only some options before
they operate.
1. Press button Départ/Pause.
The related indicator flashes.
2. Change the option set.
3. Press the button Départ/Pause again.
The programme continues.
12.11 Cancelling a running
programme
1. Press button Marche/Arrêt to cancel the
programme and to deactivate the
appliance.
2. Press button Marche/Arrêt again to
activate the appliance.
Now, you can set a new washing programme.
Before starting the new programme the
appliance could drain the water. In this
case, make sure that the detergent is still
in the detergent compartment, if not fill
the detergent again.
24
ENGLISH
12.12 The ProSense load detection
The programme duration in the display is
referred to a medium/high load.
After touching the Départ/Pause button, the
maximum declared load indicator goes off,
the indicator
the laundry load detection:
1. The appliance detects the load in the first
30 seconds: the indicator
to set the
dots flash, the drum rotates shortly.
2. At the end of the load detection, the
indicator
repeatedly
stop flashing. The programme duration
will be adjusted accordingly and could
increase or decrease. After further 30
again to
seconds, the water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Départ/Pause button to start the
programme again. The ProSense phase can
be repeated up to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The ProSense detection is carried out
with complete washing programmes only
(no skipping phase selected).
flashes, the ProSense starts
and the time
goes off and the time dots
is
Advertisement
Table of Contents
