Mitsubishi Electric TRANE NTXAMT12A112AA Service Manual page 43

• The buzzer makes a short ping sound.
NOTE
Operation is not possible for about 30 seconds after cancellation of function selection.
(Correct operation)
For description of each LED (LED 1, 2, 3) provided on the indoor controller, refer to the following table.
LED 1 (power for
microcomputer)
LED 2 (power for remote
controller)
LED 3 (communication
between indoor and outdoor
units)
AUTO RESTART FUNCTION
Indoor controller board
This model is equipped with the AUTO RESTART FUNCTION.
When the indoor unit is controlled with the remote controller, the operation mode, set temperature, and the
fan speed are memorized by the indoor controller board.
The auto restart function sets to work the moment the power has restored after power failure, then, the unit
will restart automatically.
Set the AUTO RESTART FUNCTION using the wireless remote controller. (Mode no.1).
Specifications are subject to change without notice.
NTXAMT12, 18, 24, 30, 36A112AA
Indicates whether control power is supplied. Make sure that this
LED is always lit.
Indicates whether power is supplied to the remote controller. This
LED lights only in the case of the indoor unit which is connected to
the outdoor unit refrigerant address "0".
Indicates state of communication between the indoor and outdoor
units. Make sure that this LED is always blinking.
43 © 2022 Mitsubishi Electric Trane HVAC US LLC. All rights reserved.