Cleaning Upholstery - Hoover SteamVac F59149RM Owner's Manual

CLEANING UPHOLSTERY

(Tool available on select models only)
4.10 Be sure to check the cleaning code on your upholstery. Use your
HOOVER ® SteamVac ® carpet cleaner only on upholstery marked "W" or
"W/S".
Place handle in upright position. Agitator brushes will not rotate while handle
Is In upright position.
Fill Clean Water Solution Tank with HOOVER
instructions on page 8.
Attach tool to end of hose.
IMPORTANT
Do not point tools toward people or pets.
Dry hands and plug carpet cleaner into a properly grounded outlet.
Turn carpet cleaner on. If necessary, refer to "Before using tool" section to
remove air from system.
4.11 Gently press the tool onto the fabric. Press the trigger and slowly pull the
nozzle over the fabric.
Overlap strokes by 1/2 inch to help prevent streaking.
Make additional strokes without pressing the trigger to remove more moisture.
To clean in corners or creases, lift the tool one-half inch from the fabric and
press the solution trigger.
Vacuum up the solution with the tool without pressing the trigger.
4.12 For heavily soiled areas, it may be necessary to repeat the cleaning
process. Make crisscrossing strokes to the original pattern; overlap each pass.
Make no more than 2 passes with the solution over any one area to prevent
over-wetting and damage to fabric.
If additional cleaning is necessary, wait until the upholstery is completely dry
before using the tool again.
Detergent according to
®
Actual model may vary from images shown.
15
4.10
Manufacturers tag
4.11
4.12