Starting Warm Engine - Shindaiwa 340s Operator's Manual

OPERATION
9. Pull starter handle to start the
engine.
Note: Do not pull starter rope
out to the maximum
possible position.
Note: Do not allow recoil handle
to snap back against the
casing.
Note: If engine does not start
after 5 pulls, repeat
instructions.
After starting the engine, immediately squeeze and then
◆
release throttle trigger to release fast idle throttle latch,
otherwise severe brake damage may occur.
Never use fast idle throttle latch for cutting.
◆
Use the fast idle throttle latch only in starting.
◆
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.

Starting Warm Engine

Make sure the bar and chain are free from any obstruction when
starting the chainsaw.
1. Move chain brake lever fully
FORWARD to LOCK chain
brake before starting.
2. Confirm there is fuel and chain
oil in the tanks.
32
Chain brake
X7503275905
© 10/23 ECHO Incorporated
340S