Motorola 3260FAST User Manual page 147

Table A-1.
AT Commands, Cross-Referenced to Front Panel Options (Continued)
AT Parameter &
Command Option
*
AT MN5 =9600
*
AT MN6 =12.0
*
AT MN7 =14.4
*
AT MN8 =16.8
*
AT MN9 =19.2
*
AT MN10 =21.6
*
AT MN11 =24.0
*
AT MN12 =26.4
*
AT MN13 =28.8
*
AT MN14 =31.2
*
AT MN15 =33.6
DSR
*
AT MR0 =Normal
*
AT MRl DSR=High
*
AT MR2 =DTR
*
AT MR3 =Drop on Disc
*
AT MR4 =Sim LL
AT Msg
*
AT MS0 =After CD
*
AT MS1 =Before CD
Max Rate
*
AT MX0 =300
*
AT MX1 =1200
*
AT MX2 =2400
*
AT MX3 =4800
*
AT MX4 =7200
*
AT MX5 =9600
*
AT MX6 =12.0
*
AT MX7 =14.4
*
AT MX8 =16.8
*
AT MX9 =19.2
*
AT MX10 =21.6
*
AT MX11 =24.0
*
AT MX12 =26.4
Gray shading indicates country-specific options. See Appendix C for your country's options.
A-24 Configuration Quick Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
DSR Control
Determines how the modem sets the DSR signal.
DSR is controlled by the modem.
DSR is always on.
DSR follows DTR.
The same as the normal setting except that when a disconnection is initiated from the local end,
DSR is dropped immediately.
The same as the DTR setting except DSR is dropped when the remote modem requests a
disconnect.
AT Message
Determines when the AT connect message is sent to the DTE.
The AT connect message is sent to the DTE after DCD is raised.
The AT connect message is sent to the DTE before DCD is raised.
Maximum Rate
Sets the maximum rate at which the modems communicate over the analog network. Options
available vary with the modulation mode.
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)
(V.34 modems only)