Table of Contents
Advertisement
3.2 Adjusting the Water
Temperature
WARNING
Before adjusting the water temperature, read
"To prevent burns:" on page 4 carefully.
Water temperatures above 120 °F can cause
instant scalding, severe burns, or death.
The water heater is set to 120 °F (49 °C) by default.
To adjust the water temperature:
1. Make sure that all hot water faucets are closed,
and ensure that the internal circulator and any
external circulating pumps are off.
If a hot water faucet is open, you
Note
can adjust the temperature only
from 98-110 °F (37-43 °C).
2. Press the + (Up) or – (Down) buttons until the
desired temperature appears on the display. You
can adjust the temperature while the display
is flashing. Once the display stops flashing, the
temperature setting is stored.
[Indoor Models]
or
[Outdoor Models with Remote Controller]
The water heater will retain your
Note
settings during a power outage.
You can adjust the temperature by the increments
as shown below based on the desired temperature
range.
Temperature range
98 °F-140 °F
(Fahrenheit mode)
36 °C-60 °C
(Celsius mode)
The water heater will not provide hot water instantly
at the hot water faucet unless a recirculation line has
been installed from the furthest fixture back to the
water heater.
Adjusting the water
temperature
1 °F or 0.5 °C
increments
Operating the Water Heater
11
Advertisement
Table of Contents
