Table of Contents
Advertisement
Available languages
Available languages
PRODUCT ASSEMBLY
3
Place the Bowl* on the Clamping Plate
and twist to lock in place.
5
Unlock the Motor Head and move it
down. Then, lock** the head to keep
it down. Before mixing, test lock by
attempting to raise the Motor Head.
(OPTIONAL) To adjust Beater to Bowl
Clearance: Tilt and lock** the Motor
Head back. Turn the screw slightly
counterclockwise (left) to raise the
beater, or clockwise (right) to lower it.
NOTE: If you over-adjust the screw, the
Bowl Lock Lever may not lock into place.
*The Bowl design and material depend on the Stand Mixer model.
**Locking option is available on select models.
***Included with select models only. Also available as an optional accessory.
6
4
Slide and rotate the accessory, aligning
over the pin on the shaft.
(OPTIONAL) Place the Pouring
Shield***: From the front of the Stand
Mixer, place the Pouring Shield onto
the bowl so that the Motor Head covers
the u-shaped gap in the shield. This
will position the Pouring Chute just to
the right of the Attachment Hub as you
face the mixer. Press lightly so that the
Easy Snap tabs snap the shield onto the
Bowl.
1
2
Advertisement
Table of Contents
