Table of Contents
Advertisement
Connecting the Water Line
1
Push the water tube into the hole of
the tap connector supplied in the
accessories. The pipe should be held
firmly whilst the connector is pushed
onto the pipe.
2
Ensure that the rubber washer is
fitted to the inside of the tap
connector before screwing it onto the
tap.
• A separate connector or adaptor
may need to be purchased if your
tap fitting does not match the
thread size of the connector
provided.
68
NOTE
Only For Germany
• Connect your appliance only to a water
tap with a safety device (according to
EN 1717) to avoid drinking water
pollution through water backflow.
• To be sure, please ask your installer. In
case water tap is without backflow
prevention valve (according to EN
1717), you have to use an extra
backflow prevention valve compliant
with German drinking water ordinance
between water tap and water inlet
hose.
Checking the Water
Connection
1
Turn on the water supply and switch
on the appliance. Carefully check all
fittings for possible leaks due to
poorly fitted hoses.
2
Press and hold the Water Filter
button for three seconds. The new
water filter has been activated.
3
Place a cup under the water
dispenser to verify that water is
flowing through the appliance.
4
Check the connecting tube and joints
for leaks once again.
Advertisement
Table of Contents
