Searching For Digital Terrestrial Tv Chan- Nels Manually; Automatic Service Update - Grundig 48 VLX 8481 BR User Instructions

SPECIAL­SETTINGS
Note:
The search can be aborted with »EXIT«.
7
10 Switch to the Channel Editor with »
low) ;
or
press »EXIT« to end the setting.
Searching­for­digital­terrestrial­
TV­channels­manually
1 Open the menu with »MENU«.
2 Activate the menu item »Settings« with
»OK«.
3 Select the menu item »Source Setup« with
> <
» « or » « and press »OK« to confirm.
4 Select the line »Advanced Settings« with
» « or » « and press »OK« to confirm.
V Λ
5 Select the line »Active Antenna Power« with
« or » «.
»
V Λ
Switch on the antenna power supply for the
<
antenna with »
Important:
The antenna power supply (5V ) may only
7
be switched on if the antenna is an active
indoor antenna with a signal amplifier and
it is not already supplied with a voltage via
a mains plug (or similar supply). Otherwise
you may cause a short circuit and irrepara-
bly damage your antenna.
6 Select the line »Manual Channel Search«
with » « or »
Λ V
firm.
7 Select the option »Air« with »
press »OK« to confirm
– » Manual Channel Search« menu is dis-
played.
8 Enter frequency (3-digit) directly with
»1...0«.
– Search will start.
– T he search is finished when the channels
found appear in the list.
9 Press »EXIT« to end the setting.
88­ ENGLISH
­ - ---------------------------------------------------------------------------------------

>
« or » « (»On«)
« and press »OK« to con-
< >
« or »
Automatic­service­update­
If this function is activated, possible changes of
network operators are updated automatically.
« (yel-
The unit must be located in stand-by mode.
This updating affects all types of reception - ter-
restrial, cable.
1 Open the menu with »MENU«.
2 Activate the menu item »Settings« with
»OK«.
3 Select the menu item »Source Setup« with
>
» « or »
– » Source Setup« menu is displayed.
4 Select the line »Advanced Settings« with
» « or »
V
5 Select the line »Automatic Service Update«
with »
V
update with »
6 Press »EXIT« to end the setting.
« and
<
« and press »OK« to confirm.
« and press »OK« to confirm.
Λ
« or » « and select the automatic
Λ
< >
« or » « (»On«).