GE APLS07 Owner's Manual And Installation Instructions page 5

Controls
The display will always default to show the room temperature.
When the air conditioner is turned on, it will automatically start in the last mode and fan settings selected.
Cool Mode
Use the Cool mode for cooling.
To set the Cool mode:
1. Press the MODE button until the Cool indicator light is lit.
2. Press the FAN
fan speed.
3. Press + or - to set the desired temperature.
After settings have been made, the display will change
back to show the room temperature.
The temperature control is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
temperature control at a lower number and the indoor
air will become cooler. Set the temperature control at a
higher number and the indoor air will become warmer.
Dry Mode—Dehumidification
Use the Dry mode to provide dehumidification only.
The fan will run at a fixed speed at this setting, so a fan
speed cannot be set. Keep windows and doors closed
for the best dehumidifying effects.
To set the Dry mode:
•Press the MODE button until the Dry indicator light is lit.
FAN Mode
Use the FAN mode to provide air circulation and filtering
without cooling.
To set the FAN mode:
• Press the FAN button until the desired indicator light
for high, medium, or low fan speed is lit.
HEAT Mode (for Heat/Cool models only)
Use the Heat mode at Low, Med, or High Speed for
buttons to set the desired temperature.
Power Outage Recovery Feature
automatically re-start in the settings last used after the
power is restored.
49-5000544 Rev. 4
NOTE:
while set to Cool, it will take approximately 3 minutes for
the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
temperature.
For Maximum Cooling—Select the Cool mode and
For Quieter & Nighttime Cooling—Select the
Cool mode and LOW fan speed with a middle set
temperature.
NOTE:
to OFF, wait 3 minutes before restarting.
After Dry mode has been set, the display will change
back to show the room temperature.
NOTE:
fan setting, wait at least 3 minutes before switching back
to a Dry setting.
Since fan only settings do not provide cooling, a set
temperature will not be displayed. After FAN speed has
been set, the display will change back to show the room
temperature.
The exhaust hose and window kit do not need to be
installed when operating in fan mode."
An electronic thermostat is used to maintain the room
(+) /Decrease (-) temperature. The heater will cycle on and off to keep the
room at the set level of comfort.
NOTE:
will need to be reset after power is restored.
5