Advertisement
Igniting the Barbecue
Using the CROSSOVER Ignition System to
Ignite the Barbecue
The CROSSOVER ignition system ignites the burner
furthest to the left, burner 1, with a spark from the
igniter electrode. You generate the energy for the spark
by pushing the igniter button. You will hear the igniter
clicking. Burner(s) 2 (and 3) can be lit after burner 1 is
lit. All burners should be lit for preheating, however, all
burners do not have to be lit while barbecuing.
1) Open the barbecue lid (A).
2) Check that all burner control knobs are in the off
position. Check by pushing in and turning knobs
clockwise (B).
Note: It is important that all burner control knobs are
in the off
position before turning on the LPG cylinder.
3) Turn gas supply on by turning cylinder valve
anti-clockwise or by moving regulator lever to the
on position depending on your regulator/cylinder
connection.
4) Begin with the burner furthest to the left, burner 1.
Push the burner control knob in and turn it anti-
clockwise to the start/high
position (C).
IMPORTANT: Always ignite burner 1 first. The other
burner(s) ignite from burner 1.
5) Push and hold the electronic ignition button (D).
You will hear it ticking.
6) Check that burner 1 is lit by looking through the
cooking grates and through the FLAVORIZER BARS.
7) If the burner does not ignite, turn the burner control
knob to the off
position and wait five minutes to
allow the gas to clear before attempting to light the
burner again.
8) When burner 1 ignites, you can turn on burner 2
(and burner 3).
Should the burners fail to ignite using the electronic
ignition, refer to the TROUBLESHOOTING section.
There you will find instructions on igniting the
barbecue with a match to help determine the exact
problem.
To Extinguish Burners
1) Push each burner control knob in and then turn
clockwise all the way to the off
2) Turn the gas supply off at the LPG cylinder.
B
A
position.
B
A
D
C
C
D
WARNING: Open lid during ignition.
m
WARNING: Do not lean over open barbecue
m
while igniting or cooking.
WARNING: If ignition does not occur within
m
four seconds of attempting to light the first
burner, turn the burner control knob to
the off position. Wait five minutes to allow
accumulated gas to dissipate, and then repeat
the lighting procedure.
13
Advertisement
